页面打开中,请稍候...
www.Gzu521.com
| 贵 州 学 习 网 |
|
what are the access-list ranges of ip (standard and extended) ? 1-99 ip standard access list 100-199 ip extended access list know also: 600-699 appletalk access list 800-899 ipx standard access list 900-999 ipx extended access list 1000-1099 ipx sap access list what happens to a packet which receives the end of an access list ? there is an implicit deny any at the end of an access list. so if the packet is not allowed, it will be dropped. which command is used to view the access-list on serial0 interface ? show access-lists s0 how many access-lists are possible on an interface per protocol ? there can be only one access list for in and one for out on each interface per protocol. what is the framerelay configuration command for the second subinterface ? interface s0.2 point-to-point interface s0.2 multipoint point-to-point is a direct link between two routers. multipoint is a router in the center as a star of virtual circuits. how to change the enable secret password to CCNA ? router(config)# enable secret ccna how to change the enable password to ccnp ? router(config)# enable password ccnp how to change the virtual terminal password to ccie ? router(config)# line vty 0 4 router(config-line)# login router(config-line)# password ccie how to change the auxiliary password to cisco ? router(config)# line aux 0 router(config-line)# login router(config-line)# password cisco how to change the console password to cisco ? router(config)# line con 0 router(config-line)# login router(config-line)# password cisco what is the command to show you both source and destination dlci s in one command ? i m thinking it is show frame-relay route but i m not sure. what is the command to show both source and destination addresses in ipx ? debug ipx routing activity (not sure) how are the isdn protocols defined ? i stands for concepts, terminology and services e stands for existing telephone network q stands for switching and signaling what are the correct encapsulation type of frame-relay ? cisco (default) ietf how to monitor frame-relay activity on a cisco router ? show interface s0 show frame-relay map test stats: questions: 70 pass score: 68% simulations: none (that i had) adaptive: no time: 90 minutes  本文共2页: 第 [1] [2] 页
|
责任编辑：gzu521
当前位置:
